1、功能说明
    1、GTIMA1_CH2上升沿触发GTIMA1_CH1输出一个单脉冲

2、使用环境
    软件开发环境：KEIL MDK-ARM V5.34
    软件开发环境：IAR EWARM 8.50.1

    芯片支持：
        N32H730  
        N32H735   
        N32H735EC
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787

3、使用说明
    系统配置；
        1、时钟源：HSI+PLL
        2、系统时钟频率：
            M7核: 600MHz
        3、端口配置：
			PA0选择为GTIMA1的CH1输出
			PA1选择为GTIMA1的CH2输入
			PA3选择为IO输出
        4、TIM：
			GTIMA1配置CH2上升沿触发CH1输出一个单脉冲
    使用方法：
        1、编译后打开调试模式，PA3连接PA1，用示波器或者逻辑分析仪观察GTIMA1的CH1 的波形
        2、通过调试窗口配置gSendTrigEn=1，程序发送PA3的上升沿，GTIMA1_CH1输出一个单脉冲

4、注意事项
    无
    
1. Function description
     1. The rising edge of GTIMA1_CH2 triggers GTIMA1_CH1 to output a single pulse

2. Development environment
    Software development environment: KEIL MDK-ARM V5.34
    Software development environment: IAR EWARM 8.50.1

    Supported chips:
        N32H730  
        N32H735   
        N32H735EC
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787

3. How to use
   System Configuration:
        1. Clock source: HSI+PLL
        2. System Clock frequency: 
             M7 Core:     600MHz
        3. Port configuration:
			 PA0 is selected as the CH1 output of GTIMA1
			 PA1 is selected as the CH2 input of GTIMA1
			 PA3 is selected as IO output
        4. TIM:
			GTIMA1 configures the rising edge of CH2 to trigger CH1 to output a single pulse
    Instructions:
         1. After compiling, turn on the debug mode, connect PA3 to PA1, and use an oscilloscope or logic analyzer to observe the waveform of CH1 of GTIMA1
         2. Configure gSendTrigEn=1 in the debug window,the program sends the rising edge of PA3, and GTIMA1_CH1 outputs a single pulse
4. Attention
    None

